Liaison Training Presentation
Download the current Flint Hills Resources Training Program from the links below.
Product Characteristics
The charts below provides general information about the products shipped in Flint Hills Resources’ pipelines.
Petroleum Liquids
Product:
Petroleum Liquids (crude, gasoline, diesel, jet fuel, gas oil)
Leak Type:
Liquid Color ranges from yellow to black
Vapors:
Like gasoline or diesel fuel
Health Hazards:
Flows with topography of land. Flow depends on temperature and viscosity; can be thick and slow-moving or light and able to move quickly.
Fire Hazards:
- May release vapors which are highly flammable, unstable and can be dangerous.
- Exposure may cause moderate irritation.
- Vapors may cause dizziness and cause asphyxiation without warning.
- May contain Benzene.
Petroleum Gases or Highly Volatile Liquids
Product:
Petroleum Gases or Highly Volatile Liquids (HVLs), (Propane, Butane)
Leak Type:
Transported as liquid but will vaporize into a gas at ambient pressure
Vapors:
Typically odorless when transported by pipeline. Ethylene and propylene may have faint hydrocarbon odor.
Health Hazards:
Vaporizes into a gas at ambient pressure. Vapors are heavier than air and will collect in low areas.
Fire Hazards:
- Highly flammable and easily ignited by spark or flame.
- Contact with skin may cause burns, injury, or frostbite.
- Vapors may cause dizziness and cause asphyxiation without warning.
- Fires may produce irritating or toxic gases. Vapors may form an explosive mixture with air.
Anhydrous Ammonia
Product:
Anhydrous Ammonia
Leak Type:
Gas or liquid Colorless
Vapors:
Pungent Odor
Health Hazards:
Vapors are heavier than air and will collect in low areas. Runoff may cause pollution.
Fire Hazards:
- Toxic and/or corrosive, may be fatal if inhaled, ingested or absorbed through skin. Vapors are extremely irritating and corrosive.
- Contact with gas or liquid gas may cause burns, severe injury and/or frostbite. Gasses are flammable.
How To Recognize A Pipeline Leak
Visual signs:
- Persistent bubbling in standing water
- Dead or discolored vegetation
- A sheen on the surface of standing water
- Pooling liquid on the ground
- Slight mist of ice or unexplained frozen
ground near a pipeline - A white cloud or fog
- Flames or vapors
- An unusual amount of melted snow
- Dirt blowing from a hole in the ground
Smell:
- Strange or unusual odors similar to petrochemicals
- “Rotten eggs”
Sound:
- Hissing
- Roaring
- Bubbling
- Explosions
How You Should Respond to and Report A Pipeline Emergency
The following guidelines are designed to ensure your safety and the safety of those in the area if a pipeline leak is suspected or detected.
- DO NOT operate any pipeline valves or equipment.
- Secure the area around the leak
- Evacuate the public
- Contact Flint Hills Resources as soon as possible at 1-800-688-7594
- Establish a command center
- Control ignition sources. If the pipeline leak is not burning, take steps to prevent causing any open flame or other potential source of ignition, such as an electrical switch, vehicle ignition, lighting of a match, etc.
- DO NOT use a cell phone or two-way radio near the suspected emergency area
- DO NOT attempt to put out natural gas or liquid fires. If burning, control the secondary fires
Flint Hills Resources Response to a Pipeline Emergency
In the event of a pipeline emergency involving one of our pipelines, Flint Hills Resources will respond and assist in controlling the situation.
Our trained personnel are expected to:
- Arrive at the site of the emergency and stop or reduce product flow to the area
- Notify and work with the appropriate public safety officials
- Repair the pipeline and restore the service as soon as possible
Thoroughly investigate the cause, and/or support the investigation of the appropriate regulatory agency.

